• +0086-371-86162511
  • Zhengzhou, China

Concrete Surface Grinding Portland

Stay Touch
With Us
Information Request

News & Detail

  • Concrete Information, Design Ideas, (+Contractors,

    Concrete photos, articles, info, design ideas, plus local concrete contractors for colored, stamped and textured concrete patios, driveways, pool decks, interior stained floors, concrete countertops and many more decorative concrete applications.

  • Sulfate resistance of eco-friendly and sulfate-resistant,

    The concrete mix proportions by weight ratio were cement: water: sand: crushed stones = 1: 0.59: 2.26: 3.51. The slump flow, air content, and compressive strength of concrete were measured according to Chinese standard GB/T 50080–2016 and GB 50081-2019, as shown in Table 3. After 24-hour curing, concrete samples were demolded and cured in the,

  • What Happens When Concrete Freezes? - The Portland

    Concrete Technology-Concrete Construction-Cold Weather Concreting. Weather conditions at a jobsite – hot or cold, windy or calm, dry or humid – may be vastly different from the optimum conditions assumed at the time a concrete mix is specified, designed, or selected – or from laboratory conditions in which concrete specimens are stored and tested.

  • Concrete Overlays Explained: Resurface & Repair Existing,

    We prep the concrete a couple ways. Either by lightly grinding the concrete or by pressure washing it. Sometimes both! On this one we used a 5" diamond grinder/with vacuum attached, and removed all the loose concrete. We ended up grinding the entire surface to get back down to the good concrete. About 1/8" of the surface was removed.

  • Rebound Hammer Test on Concrete - Principle, Procedure,

    The concrete surface should be smooth, clean and dry. Ant loose particles should be rubbed off from the concrete surface with a grinding wheel or stone, before hammer testing. Rebound hammer test should not be conducted on rough surfaces as a result of incomplete compaction, loss of grout, spalled or tooled concrete surface.

  • Bonding Old-to-New Concrete With Epoxy Bonding Agents

    The existing surface may be lightweight or dense portland cement concrete, asphaltic concrete (AC), steel, stone, wood or composite combinations of these materials. The bond line may be vertical, oblique or horizontal and can be on or below grade. The American Concrete Institute offers a similar set of recommendations: ACI 548.13-14.

  • 302.1R-04 Guide for Concrete Floor and Slab Construction

    4.6—Concrete placement conditions Chapter 5—Materials, p. 302.1R-20 5.1—Introduction 5.2—Concrete 5.3—Portland cement 5.4—Aggregates 5.5—Water 5.6—Curing materials 5.7—Admixtures 5.8—Liquid surface treatments 5.9—Reinforcement 5.10—Evaporation reducers 5.11—Gloss-imparting waxes 5.12—Joint materials

  • Concrete construction | Smarter Homes

    Common forms of concrete construction include concrete blocks, concrete poured into formwork and allowed to set, and precast concrete panels. Made from Portland cement mixed with sand and gravel (aggregates) and water, concrete is a hard, dense material. Cement is made by heating limestone and clay, then grinding it with gypsum.

Quick response, N-CAI Heavy Industry welcomes all sectors of society to contact us, we are waiting for your inquiry within 365x24 hours!